substrate module#

The diplexer board’s substrate.

JLCPCB’s two-layer 0.762 mm RO4350B buildup from jitxlib.jlcpcb, with one via added: the open in-pad ground via the edge-launch jacks take (launch). JLCPCB neither fills nor caps vias on its Rogers boards, so JLC02076_RO4350B offers no via-in-pad via; this one is its preferred standard via, allowed in a pad and left untented, which the fab notes say.

class DiplexerSubstrate(*args, **kwargs)[source]#

Bases: JLC02076_RO4350B

JLC02076_RO4350B with the jacks’ open in-pad ground via.

class InPadVia(*args, **kwargs)[source]#

Bases: StdViaPreferred

StdViaPreferred (0.45 mm pad, 0.30 mm drill) placed in a solder pad: plated, not filled, capped or tented.

name: str | None = 'Standard Via in Pad, Open - No Extra Cost'#

Name of the via. If not specified, the name of the class will be used. This name must be unique.

tented: set[Side] | Side | None | bool = False#

Whether the via is tented on Top, Bottom, or both sides. Untented sides will have a solder mask opening.

via_in_pad: bool = True#

Whether the via is allowed to be placed inside a component’s pads.