jitxexamples.jumpstart_kits.js4_fpga_lpddr4 package#

JS4 reference solution: the JS1 VP1002 driving a Micron LPDDR4 device, on the 18-layer reference substrate (jitxexamples.substrates.reference_18layer), taken through the layout flow part by part.

  • base: the connected board every part starts from, with its rails’ nets, calibration resistors and decoupling, only the FPGA placed, and no constraints or rules.

  • ball_field: the ball-field tag and the narrower structure a pair’s route segment inside a ball field takes.

  • reference_escapes: where a reference layout of channel B’s two byte lanes puts each strobe escape’s insertion and pair point, the positions Part 1 places them at.

  • part1_fanout_escape: Part 1’s reference, the base design with the memory placed, a via in the pad of every FPGA ball but its NC balls and every memory ball but NC and DNU, ground pours on the ground layers and channel B’s two strobe pairs escaped from both parts’ ball fields, each part’s vias and routes in the part’s own circuit so they move when that circuit moves. It leaves out of the decoupling the 27 capacitors that would connect to nothing on this board, never created.

  • part2_power: Part 2’s reference, Part 1’s design with the resistors and capacitors placed on BOTTOM in their parts’ circuits, the small capacitors across ball vias and the rest in a ring outside each field, clear of the corridor Part 4’s byte lanes take between the fields, every capacitor Part 1 keeps. It adds a pour for each of five rails on L9, L10 and L12, and the 2 oz layers’ width and clearance floors.

  • part3_si_constraints: Part 3’s reference, Part 2’s design with UG863’s timing, a loss limit, the package delay pin models and the spacing rules.

  • part4_routing: Part 4’s reference, Part 3’s design with every DQ, DMI and DQS of channel B’s byte lanes 0 and 1 routed along a reference layout’s paths (part4_reference_routes), length matched by serpentines inside length-matching sections. The data lines carry no tag, and its control points sit only at the ends of those sections.

  • constraint: UG863’s skew limits and trace length budget as a reusable constraint.

  • models: package delay pin models from a package delay file.

  • rules: UG863’s spacing between the link’s signal groups, with the under-device values on segments carrying the ball-field tag.

The FPGA’s pin offer is a supplied part, jitxexamples.jumpstart_kits.vp1002_lpddr4.

Submodules#