ball_field module#
The ball-field tag and the narrower pair structure a tagged route segment takes.
The link’s 85 ohm differential structure does not fit between the FPGA’s
balls with its open-field clearance. The segment of a pair’s route inside a
ball field takes a narrower structure instead, by a tag on that segment’s
Route at priority 4, above the structure the signal constraint applies
to the net (a routing_structure rule wins over
Constrain(...).structure on the same copper):
BallFieldPairTag on a pair segment gives it DRS_85_FIELD,
3.4/3.4/3.4 mil with 3.5 mil clearance.
A single-ended line takes no tag: the 46 ohm structure, 3.1 mil wide with
6.2 mil clearance, fits two lines between two of the FPGA’s fanout vias and
one between two of the memory’s (part1_fanout_escape, “Via
size”).
Split each pair’s route at a PairPoint about one ball pitch outside the
outermost ball row it crosses, so the full structure starts clear of the
last balls, and tag the segment between the balls and that point. The
reference board the field geometry comes from widens its pairs a median
0.7 pitch past the last ball row
(jitxexamples.substrates.reference_18layer, “Ball-field
geometry”).
The same tag stands for “under the device” in UG863’s spacing table, so the
spacing rules of rules give a tagged segment the under-device
values.
- class BallFieldTag[source]#
Bases:
TagA route segment inside a ball field. Assign its subclass to the segment’s
Route; this base names it in rule conditions.
- class BallFieldPairTag[source]#
Bases:
BallFieldTagA differential pair segment inside a ball field.
- ball_field_rules(pair, ref_net)[source]#
The ball-field structure rule at priority 4:
pairon segments taggedBallFieldPairTag, referenced toref_net.- Return type:
- Parameters:
pair (DifferentialRoutingStructure)
ref_net (Net)